Hi, Guest
08-31-2004, 10:58 AM
ever seen caesar work on a head?
I watched him work on a friend of mines...
scarey...thats all I have to say, as he scratched the s**t out of the heads sealing surface trying to remove a sensor from the head, then almost dropped the head on the floor.
plus as he removed the valves, he just let the keepers lie where they fell....and these were expensive crower keepers, and he didnt seem to care if the parts went back into the cylinder they were removed from. I find that sloppy, I am very picky about cleanliness, and organization when it comes to something as important as the internals of an engine.
I watched him work on a friend of mines...
scarey...thats all I have to say, as he scratched the s**t out of the heads sealing surface trying to remove a sensor from the head, then almost dropped the head on the floor.
plus as he removed the valves, he just let the keepers lie where they fell....and these were expensive crower keepers, and he didnt seem to care if the parts went back into the cylinder they were removed from. I find that sloppy, I am very picky about cleanliness, and organization when it comes to something as important as the internals of an engine.
SVT Motor Swap into 2000 zx3 with 5spd.
14.9 @ 93MPH
"I am going to run 5's .... I am planning on installing a rocket engine!"
14.9 @ 93MPH
"I am going to run 5's .... I am planning on installing a rocket engine!"