12-01-2005, 10:39 AM
ANTHONYD,Nov 30 2005, 09:48 PM Wrote:How'd they turn out?
[right][snapback]158616[/snapback][/right]
waiting for my LEDs to show up and the final sand/prime of the shells and then the paint goes on. To answer the concerns of the cracking issue from heat/cold. I put my lights in the freezer for a day then I put them into the oven that was set at 100F for ~10mins and the only crack I saw was in an area that's not visible. Hopefully my ghetto test is accurate.
if things go well these bad boys will be done this weekend....
***want to buy***
MBRP................ check
SCT Xcal2 ........ check
VF mounts
Adj. Dampers ... check
Meford's Mom.... sale pending
MBRP................ check
SCT Xcal2 ........ check
VF mounts
Adj. Dampers ... check
Meford's Mom.... sale pending