Hi, Guest
12-31-2005, 07:31 AM
Tri_kento,Dec 30 2005, 04:22 PM Wrote:Looks good!, but what are you going to do for the baby seat? Get one custome made to match? :P
None the less looks great, were the brackets hard to make?
[right][snapback]162555[/snapback][/right]
No the bracket was really easy once I figured out what I wanted o do. I used a piece of angle iron on the right side and a piece of flat bar on the left between the slider and the seat. Drilled a hole for the seat belt reciever to bolt thru (used the stock bolt and a nyloc nut). The thickness of the steel helped lift the seat a bit. I found it was low even though I am 6'2" tall. I also used a few washers under the front of the Sparco base to tip the seat back a little bit.
It feels great.
Focus man, Focus........ Team Psychological Disaster
2008 Taurus X to be modded.
2002 ZX5 parted out. Forever known as the "SLOCUS".
2010 Dyno #'s 102.96HP/105.84TQ
2011 Dyno #'s 111.44HP/115.17TQ
Still The Weakest Link
Dial 1-800-AUTO-PARTS for your local speed shop.
2008 Taurus X to be modded.
2002 ZX5 parted out. Forever known as the "SLOCUS".
2010 Dyno #'s 102.96HP/105.84TQ
2011 Dyno #'s 111.44HP/115.17TQ
Still The Weakest Link
Dial 1-800-AUTO-PARTS for your local speed shop.