Hi, Guest
NP... I recommend a worm-gear hose clamp as it will be quite tight to fit initially, but wear, stretching and heat loosens up the fit significantly.
That goes for anyone about to try it. It's been on for a year now on our MAF, no problems other than the fact it needs a cleaning :D
That goes for anyone about to try it. It's been on for a year now on our MAF, no problems other than the fact it needs a cleaning :D
Daily driver 1: 2007 Jeep Wrangler Unlimited Sport "S"
33" BFG Mud-Terrain KM2s, lots of Rough Country gear - bumper, 2.5" lift, swaybar disconnects, Superwinch 10,000lb winch, Detroit Locker in rear D44 axle, custom exhaust, K+N filtercharger, Superchips-tuned.
Daily driver 2: 2006 Subaru Legacy GT
COBB Stage 1+ package - AccessPort tuner, COBB intake and airbox. Stage 2 coming shortly - COBB 3" AT stainless DP and race cat, custom 3" Magnaflow-based exhaust and Stage 2 COBB tune.
33" BFG Mud-Terrain KM2s, lots of Rough Country gear - bumper, 2.5" lift, swaybar disconnects, Superwinch 10,000lb winch, Detroit Locker in rear D44 axle, custom exhaust, K+N filtercharger, Superchips-tuned.
Daily driver 2: 2006 Subaru Legacy GT
COBB Stage 1+ package - AccessPort tuner, COBB intake and airbox. Stage 2 coming shortly - COBB 3" AT stainless DP and race cat, custom 3" Magnaflow-based exhaust and Stage 2 COBB tune.