03-22-2006, 02:35 AM
Phantom,Mar 21 2006, 12:32 PM Wrote:Did you buy the connector that plugs into the oem plug in the car, or did u just stripe that end. If you bought the connector to oem, you can wire the deck harness up to the harness connector plug outside the vehicle making it easier to solder.
[right][snapback]176158[/snapback][/right]
What I did was wire the harness from the new deck, tothe stock harness connector. Like I said, the stock harness has been through 3 decks so the wires have been clipped pretty short, I'll need to replace it either way. I'm thinking the easiest way is to just start from scratch. :(
No use in trying to save the stocker harness.