04-13-2006, 07:23 AM
Madman,Apr 12 2006, 05:18 PM Wrote:OK, so I'm thinking of adding these to the Focus and just had some questions.
It seems that all the replacement lights out there use two seperate bulbs for high and low beam, yest the stock system uses one for both.
So does chaging out the lights mean modifying the wiring harness?
Thanks.
[right][snapback]180796[/snapback][/right]
Ya instead of having 1 plug, you've gotta cut into your stock harness and turn the 1 plug into 2 plugs. The high beam and low beam will each have seperate plugs. I know you can get an adapter that converts the single plug into a double plug.
The angle eyes will also need to be connect somehow. Make sure you seal the area on the headlights where the wires come out from the housing, and make sure you use the proper size resistor. If you don't do both of these things you're gonna fry the angel eyes in no time.
Current
09 F150 SCREW 4X4 XTR
Former
Show
Hella Magic Module Tail Lights, 17" Ford Racing EAP rims, 5% Rear, 20% Front Tint, Panasonic CQ7401 Deck, 2 MB Quart 10's, Alpine Components, Phoenix Gold 500.1 Amp
Go
Steeda Cold Ram Air Intake MBRP Exhaust (Gen 2), FK Coilovers, Hedman Header (Install Pending),FC Hi-Flo Cat (Install Pending),EBC Greenstuff Pads
09 F150 SCREW 4X4 XTR
Former
Show
Hella Magic Module Tail Lights, 17" Ford Racing EAP rims, 5% Rear, 20% Front Tint, Panasonic CQ7401 Deck, 2 MB Quart 10's, Alpine Components, Phoenix Gold 500.1 Amp
Go
Steeda Cold Ram Air Intake MBRP Exhaust (Gen 2), FK Coilovers, Hedman Header (Install Pending),FC Hi-Flo Cat (Install Pending),EBC Greenstuff Pads