Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
$%^#$@ Tie Rod End
#1
Is there a trick to get these unscrewed from the rest of the tie rod? I've tried everything I can think of and its not moving. Heat, swearing, holy water, you name it. Put some PB Blaster on it and letting it soak overnight, and will see what happens, but I'm not feeling very optimistic.
The new: 2013 Tangerine Scream ST
The old: 2005 ZX4 - MBRP 2.25", Marcy Motorsport CAI. SCT Tuning, Eibach Pro-System
--
Team PITA
Reply
#2
I tightened a pair of vice grips on the arm that goes into the steering rack then wedged it between the control arm and loosened the tie rod end with a open ended wrench. Has always worked for me :)
2004 Ford Focus ZX5 MTX75 - Liquid Grey -

15.7 @ 86mph

1994 Pontiac Trans AM 25th Anniversary 6 spd -

12.3 @ 110mph

2013 Ford Focus ST - Oxford White

1/4 TBD
[Image: image,Burnin1,black,blue.png]
Reply
#3
Burnin21,Apr 5 2010, 08:36 PM Wrote:I tightened a pair of vice grips on the arm that goes into the steering rack then wedged it between the control arm and loosened the tie rod end with a open ended wrench. Has always worked for me :)
[right][snapback]304607[/snapback][/right]



Why do I have a feeling I've watched you do this?
Reply
#4
torradan,Apr 5 2010, 06:58 PM Wrote:Is there a trick to get these unscrewed from the rest of the tie rod?  I've tried everything I can think of and its not moving.  Heat, swearing, holy water, you name it.  Put some PB Blaster on it and letting it soak overnight, and will see what happens, but I'm not feeling very optimistic.
[right][snapback]304604[/snapback][/right]

If you peel back the rubber gromet, there are two flat spots where you can attach a 17mm open end wrench. Use another 17mm wrench on the front. However, I was unable to break the bolt loose. I have heard you will need a breaker bar, but you will need to position it in the wheel well somehow.

In the end I gave up, and paid the local ford dealer $90 to do it.
Reply
#5
ANTHONYD,Apr 5 2010, 09:28 PM Wrote:
Burnin21,Apr 5 2010, 08:36 PM Wrote:I tightened a pair of vice grips on the arm that goes into the steering rack then wedged it between the control arm and loosened the tie rod end with a open ended wrench. Has always worked for me :)
[right][snapback]304607[/snapback][/right]



Why do I have a feeling I've watched you do this?
[right][snapback]304609[/snapback][/right]

Thats what had to be done to the green monster I believe :lol:
2004 Ford Focus ZX5 MTX75 - Liquid Grey -

15.7 @ 86mph

1994 Pontiac Trans AM 25th Anniversary 6 spd -

12.3 @ 110mph

2013 Ford Focus ST - Oxford White

1/4 TBD
[Image: image,Burnin1,black,blue.png]
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)