Yeah, all by myself...finally got the sucka up and bolted in...
Here is my custom made shifter busging installed...
![[Image: HPIM2116.jpg]](http://i102.photobucket.com/albums/m91/WuNgUn/HPIM2116.jpg)
So basically, what I did was plop the Getrag into a milk crate, with the car up in the air, and slid it into position...
![[Image: HPIM2117.jpg]](http://i102.photobucket.com/albums/m91/WuNgUn/HPIM2117.jpg)
I carefully jacked the car down to get a better alignment...
![[Image: HPIM2118.jpg]](http://i102.photobucket.com/albums/m91/WuNgUn/HPIM2118.jpg)
And wiggled and tilted and lifted it up into place...started a few bolts top and bottom to draw it in...
![[Image: HPIM2119.jpg]](http://i102.photobucket.com/albums/m91/WuNgUn/HPIM2119.jpg)
And that's it!!
Wasn't too difficult, but I worry that maybe with my wiggling and tilting, that I might of caused damage to the main seal, or the throw out bearing...? Scary thought..
Time will tell!
That's as far as I got when I broke the bulb in my trouble light!! Dammit!
Oh, and the custome shifter bushing installed and cable mounted...
![[Image: HPIM2122.jpg]](http://i102.photobucket.com/albums/m91/WuNgUn/HPIM2122.jpg)
I'm a little concerned that the one I've sold will be seriously difficult to install with the tranny still in the car!!!
Here is my custom made shifter busging installed...
![[Image: HPIM2116.jpg]](http://i102.photobucket.com/albums/m91/WuNgUn/HPIM2116.jpg)
So basically, what I did was plop the Getrag into a milk crate, with the car up in the air, and slid it into position...
![[Image: HPIM2117.jpg]](http://i102.photobucket.com/albums/m91/WuNgUn/HPIM2117.jpg)
I carefully jacked the car down to get a better alignment...
![[Image: HPIM2118.jpg]](http://i102.photobucket.com/albums/m91/WuNgUn/HPIM2118.jpg)
And wiggled and tilted and lifted it up into place...started a few bolts top and bottom to draw it in...
![[Image: HPIM2119.jpg]](http://i102.photobucket.com/albums/m91/WuNgUn/HPIM2119.jpg)
And that's it!!
Wasn't too difficult, but I worry that maybe with my wiggling and tilting, that I might of caused damage to the main seal, or the throw out bearing...? Scary thought..
Time will tell!
That's as far as I got when I broke the bulb in my trouble light!! Dammit!
Oh, and the custome shifter bushing installed and cable mounted...
![[Image: HPIM2122.jpg]](http://i102.photobucket.com/albums/m91/WuNgUn/HPIM2122.jpg)
I'm a little concerned that the one I've sold will be seriously difficult to install with the tranny still in the car!!!