Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Average Price
#1
hey guys, just curious, but what would be an average price for someone to install exhaust. I'm curious cause mine is going on 2morro, and i wanna know if he's ripping me off or not
Reply
#2
smith21,Sep 26 2005, 09:04 PM Wrote:hey guys, just curious, but what would be an average price for someone to install exhaust. I'm curious cause mine is going on 2morro, and i wanna know if he's ripping me off or not
[right][snapback]144973[/snapback][/right]

It doesn't take long if you know what you're doing. With the right tools, probably 45min to one hour. It depends on the labour rate/hr... I think general labour rates at automotive shops are like 75-85bucks/hr. Who's installing it for you in Sudsbury?
Sold:2001 SE 2.0L SPI w/60mm TB, Steeda Shorty Intake.

Active: 2007 SES Hatch, Motegi MR7 Rims with 215/45ZR17 Michelin Pilot Super Sport Tires, debadged, black painted calipers and drums, RS Knob, CFM Short Throw, Billet E-Brake, CFM Focus pedals, MBRP Exhaust, XCal2, FS Front and Rear Strut Tower Bars, Diamond Plate Floor Mats and Sills, Alpine MP3 Deck, Alpine V-Power 300w Amp, Pioneer IMPP Sub, AlpineType-S door speakers, VF Engineering Rear Motor Mount, F2 RS Spoiler, Tokico D-spec shocks, HTP Cross Brace, EBC Rotors, Hawk HPS Pads, Russell SS Brake Lines, RS Wheel, SVT Blue Seats, Vibrant 2.5" Race Highflow Cat, CFM UDP. Rear SVT bumper to come.

Active: 2005 Jeep Wrangler Unlimited TJ [LJ], Volant CAI, 32" BFG Mud Terrains, and a whole bunch of goodies. Big Grin
Reply
#3
Oscar The Grouch,Sep 26 2005, 10:09 PM Wrote:It doesn't take long if you know what you're doing.  With the right tools, probably 45min to one hour.  It depends on the labour rate/hr...  I think general labour rates at automotive shops are like 75-85bucks/hr.  Who's installing it for you in Sudsbury?
[right][snapback]144986[/snapback][/right]

Gil's brake shop. Was going to get the Muffler shop, but he couldn't garantee to get it done when i wanted it to be done, which was 2morro morning.
Reply
#4
I paid Midas $45 to install mine. He was finished in under 45 mins!

Skirt, Volant Intake, HID projectors, Eibach Suspension, SVT rims
Reply
#5
is 63 something too much? that's what i got charged, it was $50 labour, 2.25 for a gasket seal thing, and then tax obviously. Too much?
Reply
#6
I'd say you didn't pay too much, looks like you got charged for an hours labour and the gasket. Which gasket did you need? When i did my MBRP it came with all the gaskets. Thats the only thing that seems a little bit odd to me.
Current
09 F150 SCREW 4X4 XTR

Former
Show
Hella Magic Module Tail Lights, 17" Ford Racing EAP rims, 5% Rear, 20% Front Tint, Panasonic CQ7401 Deck, 2 MB Quart 10's, Alpine Components, Phoenix Gold 500.1 Amp
Go
Steeda Cold Ram Air Intake MBRP Exhaust (Gen 2), FK Coilovers, Hedman Header (Install Pending),FC Hi-Flo Cat (Install Pending),EBC Greenstuff Pads

Reply
#7
Gaskets came with my kit as well... :huh:

Skirt, Volant Intake, HID projectors, Eibach Suspension, SVT rims
Reply
#8
ZX3guy2000,Sep 27 2005, 10:47 AM Wrote:Gaskets came with my kit as well... :huh:
[right][snapback]145062[/snapback][/right]

If they used gasket sealant, its like an orange stuff, I wouldn't be surprised. But if they charged you for an additional gasket, check it out and yell at someone. :ph34r:
Sold:2001 SE 2.0L SPI w/60mm TB, Steeda Shorty Intake.

Active: 2007 SES Hatch, Motegi MR7 Rims with 215/45ZR17 Michelin Pilot Super Sport Tires, debadged, black painted calipers and drums, RS Knob, CFM Short Throw, Billet E-Brake, CFM Focus pedals, MBRP Exhaust, XCal2, FS Front and Rear Strut Tower Bars, Diamond Plate Floor Mats and Sills, Alpine MP3 Deck, Alpine V-Power 300w Amp, Pioneer IMPP Sub, AlpineType-S door speakers, VF Engineering Rear Motor Mount, F2 RS Spoiler, Tokico D-spec shocks, HTP Cross Brace, EBC Rotors, Hawk HPS Pads, Russell SS Brake Lines, RS Wheel, SVT Blue Seats, Vibrant 2.5" Race Highflow Cat, CFM UDP. Rear SVT bumper to come.

Active: 2005 Jeep Wrangler Unlimited TJ [LJ], Volant CAI, 32" BFG Mud Terrains, and a whole bunch of goodies. Big Grin
Reply
#9
Oscar The Grouch,Sep 27 2005, 10:50 AM Wrote:[If they used gasket sealant, its like an orange stuff, I wouldn't be surprised.  But if they charged you for an additional gasket, check it out and yell at someone. :ph34r:
[right][snapback]145063[/snapback][/right]

it was the gasket sealant s**t..sorry, i didn't specify :rolleyes:
Reply
#10
smith21,Sep 27 2005, 04:46 PM Wrote:it was the gasket sealant s**t..sorry, i didn't specify  :rolleyes:
[right][snapback]145128[/snapback][/right]

Good. So how does the exhaust sound now?
Sold:2001 SE 2.0L SPI w/60mm TB, Steeda Shorty Intake.

Active: 2007 SES Hatch, Motegi MR7 Rims with 215/45ZR17 Michelin Pilot Super Sport Tires, debadged, black painted calipers and drums, RS Knob, CFM Short Throw, Billet E-Brake, CFM Focus pedals, MBRP Exhaust, XCal2, FS Front and Rear Strut Tower Bars, Diamond Plate Floor Mats and Sills, Alpine MP3 Deck, Alpine V-Power 300w Amp, Pioneer IMPP Sub, AlpineType-S door speakers, VF Engineering Rear Motor Mount, F2 RS Spoiler, Tokico D-spec shocks, HTP Cross Brace, EBC Rotors, Hawk HPS Pads, Russell SS Brake Lines, RS Wheel, SVT Blue Seats, Vibrant 2.5" Race Highflow Cat, CFM UDP. Rear SVT bumper to come.

Active: 2005 Jeep Wrangler Unlimited TJ [LJ], Volant CAI, 32" BFG Mud Terrains, and a whole bunch of goodies. Big Grin
Reply
#11
Sounds really nice :) , i even have my ricer friends leaning towards my exhaust over theirs
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)