Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Eyelid Redo
#1
Okay, I wasn't completely happy with how low the eyelids on my headlights went, so i redid them. This time i didn't bother with taking them off the car...(tooooo much work), so i masked them this time.

Now, i think they look better, and the chrome on the top part of my housing is completely covered...much better i think.


original eyelid and how much more i wanted to add. almost a 1/2 inch

[Image: Picture003.jpg]
[Image: 9a98adc9.jpg]
[Image: d230732f.jpg]
[Image: Picture008.jpg]
[Image: Picture015.jpg]
[Image: Picture014.jpg]
[Image: Picture013.jpg]
[Image: Picture012.jpg]
[Image: Picture016.jpg]

A little bit of light bleeds out the top..i'll fix that with touch up...

[Image: Picture019.jpg]
"The weak shall inherit...........NOTHING"
Mods so far:
- 2 Inch Drop, Focus Sport Cold Air Intake, Street Glow 4 light strobe system,MBRP Cat back exhaust, 35% tint on front windows, 5% all around the rear. 1 Million Color Flowlighting Underglow kit, Inside and out. SPEEDHUT custom indiglo Guages, Sirius Satellite Radio, Pioneer DH6800 Deck, 15" Solo-Baric L7 Sub,Enkei 17 inch rims, Belltronic Radar Detector
Reply
#2
look good dude, and yea, you gotta fix that light on the top seeping through
Reply
#3
Looks good! But the light coming through the tops of both is noticeable still, as Smith21 posted.
'14 Escape 2.0t
2012 5dr Ti : Traded
Reply
#4
I preferred the eyelids as they were when you did them the first time. Just me tho
2000 Black ZX3
Blacked Out Head & Tail lights - APC Clear Turn Signals - 20% Tint All Round - K&N Filter - Cheap ass fogs that are brighter than my headlights - Clarion DXZ745MP - Jensen XA 4100 amp on Mobile Authority 200w 6x8's - Jensen 340w amp on a 12" Rockford Sub, custom enclosure - KYB GR2 Dampers - SHM Springs @ 1.5" - Brembo Cross Drilled Rotors w/ CVR Ceramic Pads - Silver Gauge Bezel - Focus Central 2-Piece Under Drive Pullies - 17 x 7 Rims by Fast Wheels mounted on 215/40/17's - Wings West W-Typ front lip - Coming Soon: Paint, Component Speakers (Spring 06)
Reply
#5
Raine,Oct 16 2005, 09:32 AM Wrote:I preferred the eyelids as they were when you did them the first time. Just me tho
[right][snapback]149403[/snapback][/right]

Im with Raine...It looks to much...but it's just my 2 cent!

Still looks good
Turbo arrived!
Reply
#6
I still think it looks better, props for doing it all yourself...
Reply
#7
You got balls painting your headlights in the first place, nevermind on the car.
Reply
#8
it looks ok, kinda like a Mondeo now they way it currently looks.
I was the only member on this board with a Yellow Focus Sedan, and a 2002+ Euro Facelift on a sedan.
Reply
#9
01-yellow-ZX3,Oct 16 2005 Wrote:You got balls painting your headlights in the first place, nevermind on the car.
[right][snapback]149421[/snapback][/right]

Yeah I agree, I personally would have went the vinyl route but it would be a PITA to get them to color matched. Too bad someone wouldn't bring out a set like the KAMEI ones they make for the pre 2005 ones.
Reply
#10
I'm just a stickler for details, but fix the light coming through the top. It cheapens the whole experience. :(
Reply
#11
Yeah a touch-up will fix it.

I'm in the "it looks better now than it did before" camp. Good job!
Daily driver 1: 2007 Jeep Wrangler Unlimited Sport "S"

33" BFG Mud-Terrain KM2s, lots of Rough Country gear - bumper, 2.5" lift, swaybar disconnects, Superwinch 10,000lb winch, Detroit Locker in rear D44 axle, custom exhaust, K+N filtercharger, Superchips-tuned.

Daily driver 2: 2006 Subaru Legacy GT

COBB Stage 1+ package - AccessPort tuner, COBB intake and airbox. Stage 2 coming shortly - COBB 3" AT stainless DP and race cat, custom 3" Magnaflow-based exhaust and Stage 2 COBB tune.
Reply


Forum Jump:


Users browsing this thread: 2 Guest(s)