WuNgUn's custom machined Getrag shifter bushing... - Printable Version +- FocusCanada Forums (//www.focuscanada.net/forum) +-- Forum: Technobabble (//www.focuscanada.net/forum/forumdisplay.php?fid=4) +--- Forum: Focus on Performance (//www.focuscanada.net/forum/forumdisplay.php?fid=22) +--- Thread: WuNgUn's custom machined Getrag shifter bushing... (/showthread.php?tid=19391)

WuNgUn's custom machined Getrag shifter bushing... - WuNgUnSVT - 08-13-2011 Picked up a few of the sleeves from the machine shop...more coming. Went with a better quality, shoulder (stripper) bolt, nylock nut and washer... PM me if you have any questions! (This is for the large, white shifter bushing on the tranny...) You basically grind off and drill a 1/4" hole where the linkage stub use to be, and bolt this to the linkage instead. And of course, you have to gut the worn-out, spongy rubber out of the nylon cable end... RE: WuNgUn's custom machined Getrag shifter bushing... - hardk0re - 08-13-2011 I take it you are selling them? Do you have a solution like this for the side to side slop with the square bushing? RE: WuNgUn's custom machined Getrag shifter bushing... - WuNgUnSVT - 08-13-2011 Officially, not selling them....I don't know about the policies on this forum...? But if you want one, PM me... For the square bushing, you simple remove it, turn it 90 degrees, and reinstall it... It's all in the instructions I provide. RE: WuNgUn's custom machined Getrag shifter bushing... - WuNgUnSVT - 08-14-2011 I have just 6 left...anyone interested, PM me... RE: WuNgUn's custom machined Getrag shifter bushing... - WuNgUnSVT - 08-17-2011 Bump... RE: WuNgUn's custom machined Getrag shifter bushing... - WuNgUnSVT - 08-20-2011 Here are the install instructions... http://www.fileden.com/files/2007/12/23/1659779//Shifter Bushing Replacement Mod rev.3.pdf RE: WuNgUn's custom machined Getrag shifter bushing... - WuNgUnSVT - 09-03-2011 Still available... RE: WuNgUn's custom machined Getrag shifter bushing... - WuNgUnSVT - 09-12-2011 Here is the bushing mounted to the trans... And in the car, with the cable attached...