Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
A/f Gauge Install.
#1
Ok So I hooked up my A/F Gauge today.

Seems to be working, I just understand 1 thing.

Before anyone Says it, Yes Its a NB A/F And Yes its good to have when your running a Chip.

I hooked it up to the Black with yellow Stripe,
My Readings are A little above lean(Not red, All Orange)
But I always get 1 Green flash at Full Rich...

If this is Normal let me know please.
Reply
#2
Ok Disconnect from the Black Wire... DIdnt seem right.

Hooked it up to the White wire, Works perfectly.

Dosent jump around like everyone said it would.
Reply
#3
:postpics:

Sorry had to be said :P
Current
09 F150 SCREW 4X4 XTR

Former
Show
Hella Magic Module Tail Lights, 17" Ford Racing EAP rims, 5% Rear, 20% Front Tint, Panasonic CQ7401 Deck, 2 MB Quart 10's, Alpine Components, Phoenix Gold 500.1 Amp
Go
Steeda Cold Ram Air Intake MBRP Exhaust (Gen 2), FK Coilovers, Hedman Header (Install Pending),FC Hi-Flo Cat (Install Pending),EBC Greenstuff Pads

Reply
#4
Chromey,Oct 9 2005, 03:54 PM Wrote:Dosent jump around like everyone said it would.
[right][snapback]147770[/snapback][/right]

Then it snot working properly. unless the guage does something that most guages dont... <_<
[Image: ncclogo.jpg]
Reply
#5
At Idle It moves back and forth like the "Night Rider Car"

At WOT Its all Rich, Off gas its Lean.

Seems to work right to me..
Reply
#6
Chromey,Oct 9 2005, 11:12 PM Wrote:At Idle It moves  back and forth like the "Night Rider Car"

At WOT Its all Rich, Off gas its Lean.

Seems to work right to me..
[right][snapback]147809[/snapback][/right]

whats it doing while cruising?
[Image: ncclogo.jpg]
Reply
#7
Same as Idle, Back and Forth.. And a Nice speed .
Reply
#8
i was thinking jumping around and going back and forth was the same.

my bad
[Image: ncclogo.jpg]
Reply


Possibly Related Threads...
Thread Author Replies Views Last Post
  How Do You Install Air/fuel Ratio Gauge nvybluzx5 6 4,870 04-27-2004, 05:49 AM
Last Post: bill1459

Forum Jump:


Users browsing this thread: 1 Guest(s)