Hi, Guest
08-19-2007, 08:47 PM
its pretty easy ...
. boil some water on the stove ....
.heat tip in it
.pull it off with fingers or oven mit
.I cut mine about 3/4 way down ( I used lineman pliers that were sharp..ps might be a good spot to use gloves if you got em I got a little fiberglass in my fingers) didnt hurt my reception ... you can just see it with roof open.
. then what I did was put the tip on just a little and put it back in the boiling water and worked it on little by little making sure the lign was straight
worked awesome and looks perfect .
. boil some water on the stove ....
.heat tip in it
.pull it off with fingers or oven mit
.I cut mine about 3/4 way down ( I used lineman pliers that were sharp..ps might be a good spot to use gloves if you got em I got a little fiberglass in my fingers) didnt hurt my reception ... you can just see it with roof open.
. then what I did was put the tip on just a little and put it back in the boiling water and worked it on little by little making sure the lign was straight
worked awesome and looks perfect .
Ford Focus SES ZX5
Blue Underglow, Clear Corners, Shorty antenna, vogtland springs , Rust Module,Truebendz 2.5 ss magnaflow and Fuzion 205/50/16 HRI's
TEAM DURATEC # 99
Blue Underglow, Clear Corners, Shorty antenna, vogtland springs , Rust Module,Truebendz 2.5 ss magnaflow and Fuzion 205/50/16 HRI's
TEAM DURATEC # 99