09-03-2007, 04:32 AM
putting in oven or other method to open headlights and few screws holding inside bezel, take that out, sand lightly, primer, base coat..let it dry, reassemble silicone to seal it back..
but be careful with oven method, tab melts under lower temp than other parts..
it is all about patient.
but be careful with oven method, tab melts under lower temp than other parts..
it is all about patient.
BLACKBOX(DASHCAM) | LED | HID | REMOTE STARTER + SECURITY | 12 VOLT ACCESSORIES | CAR ENTERTAINMENT | PERFORMANCE UPGRADE | MAINTENANCE REPAIR
info@motormaniac.ca | 905.508.3737
If you are calling after hours, please leave a pm or detailed voice mail and we will get back to you as soon as possible.
info@motormaniac.ca | 905.508.3737
If you are calling after hours, please leave a pm or detailed voice mail and we will get back to you as soon as possible.