Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Heat Shields
#1
Finally my heat shield under the car has let go, it is the one just under the passenger seats.

I remember reading that it was OK to just remove it, anybody do this without adverse effects? Or should I simply try and bolt it back up with some pieces of metal or large washers?
Reply
#2
I tried to re attach it with big washers and it just fell off again. Just rip it off i have have had nothing bad happen after it has been removed.
Reply
#3
i took all mine off. if your overlly concearned you can spray some bed liner under there
2000 dark violet pearl zx3: eagle rods, je pistons, fidanza cam gears, arp studs, ford racing highlift valve springs, svt front/rear disc conversion, prothane total kit, fc 65mm throttle body Tial gt3071r, tial mvs wastegate, tial Q bov, top speed "street" manifold,down pipe and dump tube, greddy boost controller, siemens deka #61 injectorz, stage 4 bully clutch way to much more to list
Instagram @o_so_slo
Reply
#4
Good stuff time to cut it off.
Reply
#5
I think mine have been gone for years. I had them repaired a few times under warranty but with no luck.
[Image: sigfocuscanada.jpg]
Reply


Forum Jump:


Users browsing this thread: 2 Guest(s)