Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Brakes Or Wheelbearings
#1
Hey guys....

The Svt is making some wierd nosies seems that theres a slight grinding coming from the wheel. which wheel yet... not too sure.

I've come to the conclusion its one of three things...

Wheel Bearings

Sticking caliper

Warped rotor.


Symptoms: low speed crusing. i feel a slight grinding in the wheel. and hear a rubbing noise coming from outside the car.... if i tap the brakes. the sound goes away for a few seconds then comes back... at highway speeds i dont really feel anything.

oh yeah, the wheel doesnt vibrate while braking so that may rule out warped rotor

brakes were changed 15k ago. and from what i can see the pads are fine.... and its also not a metal on metal type of grinding.

any ideas?

tonight i'm going to jack up the car when i get home from work and spin each of the wheels hopefully i can find the cause.
05 Altima SE-R
98 Grand Cherokee 5.9: Flowmaster; K&N
05 300C 5.7: Sold
99 Civic SIR: Sold
03 Focus SVT: Sold
01 Focus ZX3: Sold
Reply
#2
My wheel bearing was replaced last week. My symptoms were a thud noise whenever the wheels were truning.....didnt matter what speed/breaking, etc....the noise was always there.
[Image: ncclogo.jpg]
Reply
#3
if its the wheel bearing i'm gonna flip the damn out at dixie ford...

last 3 times the car was there i said wheel bearing

theyre like... no...

especially since the car is out of warranty.
05 Altima SE-R
98 Grand Cherokee 5.9: Flowmaster; K&N
05 300C 5.7: Sold
99 Civic SIR: Sold
03 Focus SVT: Sold
01 Focus ZX3: Sold
Reply
#4
my car was doin the same thing, i got new brakes and it was fine ,they said my calipers had seized on one of the brakes........check the break pad, see how much is left
Reply
#5
Could be a bearing but sounds like brakes rubbing really.
My Mom Says I'm Special
Reply
#6
Steve, I know you said your gonna sell it @ 90,000km's. I just hope for you that it makes it that far. Damn, your car is cursed. What's the build number anyways? Hopefully mine wasn't made anywhere near yours.
Reply
#7
499/2173...

i was going to wait till feb when i move. but now i'm waiting. damn. i really dont wanna pull down my brakes this weekend.
05 Altima SE-R
98 Grand Cherokee 5.9: Flowmaster; K&N
05 300C 5.7: Sold
99 Civic SIR: Sold
03 Focus SVT: Sold
01 Focus ZX3: Sold
Reply
#8
If yah need brakes yah should all go to napa and get thier new ceramix line
My Mom Says I'm Special
Reply
#9
I certainly hope it doesnt need brakes....

I just put EBC greenstuff on all 4 corners 3 months ago
05 Altima SE-R
98 Grand Cherokee 5.9: Flowmaster; K&N
05 300C 5.7: Sold
99 Civic SIR: Sold
03 Focus SVT: Sold
01 Focus ZX3: Sold
Reply
#10
Must be a wheel bearing then, when yah jack it up check for play in the wheel, if there is more then likely it's a bearing, unless something else is loose.
My Mom Says I'm Special
Reply
#11
Yeah, the only thing stopping me from thinking its the bearing is that when i tap the brake. the noise stops for 3 or 4 seconds after the pedal is released....

I hope its just some dirt or something. that i can solve with a bit of brake cleaner.
05 Altima SE-R
98 Grand Cherokee 5.9: Flowmaster; K&N
05 300C 5.7: Sold
99 Civic SIR: Sold
03 Focus SVT: Sold
01 Focus ZX3: Sold
Reply
#12
Maybe this?


TSB 03-20-2: Suspension Creaking

--------------------------------------------------------------------------------

This applies to all Foci produced from 2000 to 2003. I'll assume it's also a *possible* issue on SVT models:


SUSPENSION - Creaking, crunching, grinding or rattle noise from front suspension at slow speeds over bumps and/or while turning

NOISE - Creaking, crunching, grinding or rattle noise from front suspension at slow speeds over bumps and/or while turning

Article Application: Supercedes TSB 03-15-3

Reply
#13
I dont think it would be the suspension. because it happens when the car is going in a straight line. bumps dont effect it.
05 Altima SE-R
98 Grand Cherokee 5.9: Flowmaster; K&N
05 300C 5.7: Sold
99 Civic SIR: Sold
03 Focus SVT: Sold
01 Focus ZX3: Sold
Reply
#14
turned out to be a broken stud....Must have been built ford tough strange how the lugnut was still there...
05 Altima SE-R
98 Grand Cherokee 5.9: Flowmaster; K&N
05 300C 5.7: Sold
99 Civic SIR: Sold
03 Focus SVT: Sold
01 Focus ZX3: Sold
Reply
#15
Dang, at least that's all it was. How many KMs? 75,000? Or closer to your sig?
Daily driver 1: 2007 Jeep Wrangler Unlimited Sport "S"

33" BFG Mud-Terrain KM2s, lots of Rough Country gear - bumper, 2.5" lift, swaybar disconnects, Superwinch 10,000lb winch, Detroit Locker in rear D44 axle, custom exhaust, K+N filtercharger, Superchips-tuned.

Daily driver 2: 2006 Subaru Legacy GT

COBB Stage 1+ package - AccessPort tuner, COBB intake and airbox. Stage 2 coming shortly - COBB 3" AT stainless DP and race cat, custom 3" Magnaflow-based exhaust and Stage 2 COBB tune.
Reply
#16
Must have broke teh stud wit all dat p0wah yo!1!1!!!!
Reply
#17
SPV 4 life. :ph34r:
[Image: ncclogo.jpg]
Reply
#18
72650

also i had the rotors turned... due to a slight rubbing issue.
05 Altima SE-R
98 Grand Cherokee 5.9: Flowmaster; K&N
05 300C 5.7: Sold
99 Civic SIR: Sold
03 Focus SVT: Sold
01 Focus ZX3: Sold
Reply
#19
"The rotars were contacting the break peds... so we dun turned em" :rofl:
Daily driver 1: 2007 Jeep Wrangler Unlimited Sport "S"

33" BFG Mud-Terrain KM2s, lots of Rough Country gear - bumper, 2.5" lift, swaybar disconnects, Superwinch 10,000lb winch, Detroit Locker in rear D44 axle, custom exhaust, K+N filtercharger, Superchips-tuned.

Daily driver 2: 2006 Subaru Legacy GT

COBB Stage 1+ package - AccessPort tuner, COBB intake and airbox. Stage 2 coming shortly - COBB 3" AT stainless DP and race cat, custom 3" Magnaflow-based exhaust and Stage 2 COBB tune.
Reply
#20
Ford SRT

Special
Recall
Team
My other ride is your Mom
Reply


Forum Jump:


Users browsing this thread: 2 Guest(s)